STAR SECURITY BARRIERS MOBILE TRAFFIC CONTROL Check point Car Truck Road Spike

Description

STAR SECURITY BARRIERS MOBILE TRAFFIC CONTROL BARRIER
HEAVY    DUTY   SERIOUS   GEAR  !!
SUPER  EASY AND FAST SETUP  !!!!
Less than 90 seconds from  Picture #2  layout  to  setup & locked in picture #3
If  you need;  Less than a minute to run security rope or even steel cable through eyes
to immobilize.
If a car or truck tries to run over these barriers, it will most certainly be a memorable event for the vehicle and the person
driving the vehicle.  VERY  High probability for the vehicle to be damaged to the point of needing repairs.
There were 3 STARS on this listing when started;  . . . . . . You  are bidding on ONE.
And,
It's Your choice to buy 1, 2, or all 3 !
Star Security Barriers, fast and easy setup.  Can deploy multiple barriers in minutes.
Each unit comes with a Tilt latch pin for easy setup.
Units are constructed of 21" long, 1.5" square, 1/8" thick tubing and have a 1.5" spike welded to each end.
Units fold up to be 24"L x 5.5"H x 5.5"W
Units working height is 16"
Individual unit weight is 15lbs.
These units came from Smith & Wesson security and are now sold by FutureNet security solutions.
Type
Mobile Traffic Control Barrier
Ideal For
Police checkpoints, military checkpoints,  or
event   security
For a fast and convenient solution at mobile checkpoints, the STAR Barrier provides an alternate solution to time-consuming concertina wire as a traffic barrier. Each STAR is equipped with three steel spikes, which cause considerable damage to a vehicle, and is attached to other STARs using cabling. Multiple STARs form an effective blockade at varying lengths to channel traffic through checkpoints, without the hassle of ineffective road cones or complicated concertina wire.
The lightweight and compact storage of the STAR Barrier make it ideal for fast checkpoint setup. When not in use, each STAR folds into a compact, uniform position for storage in its own case. Setup and breakdown of the STAR Barrier is achieved in just four steps, and does not require special training or certification to deploy like concertina wire.
APPLICATION
Control traffic
Protect work zone areas
Create a visual deterrent
Create rolling check points
Block off access control points
Shut down unprotected areas from vehicle access
Disable vehicles
FEATURES AND BENEFITS
Quick and simple set-up
High visibility
Lightweight
Low cost
Easy to store and transport
No special training necessary
INSTALLATION STEPS
Remove one STAR “I” and one STAR “X” from the box.
Lay the “I” off to the side and prop up the “X” as demonstrated.
Grab the “I” and slide it through the boxhole on the “X” until it comes in contact with the stop bar. The STAR Barrier is in the correct position when the stop bar is on the underside (on the leg that points to the ground) of the barrier.
Connect one end of the Lanyard to the openings on the STAR Barrier. Connect the other end of the Lanyard to another assembled STAR Barrier.